ABOJET® CRACK-INJECTION SYSTEM: “Weld” Cracked Structural Elements Back Together.
Uses: Restore monolithic integrity to cracked structural elements by injecting an epoxy compound into cracked to fill and “weld” it back together. Seals foundations and below grade walls against water seepage. The Abojet series of resins is most commonly used in the restoration of load-bearing walls such as foundations, retaining walls, abutments, swimming pools, dams, decks, silos, bridge piers, columns, domes, concrete pipes, and tanks.
Features and Benefits: Since Abojet bonds permanently and is stronger than concrete, the “welded” wall can be stronger than the original. It is the perfect solution where structural requirements cannot be compromised and a dependable cost-effective alternative to demolition.
The Abojet Crack Injection Process: The Abojet system consists of a resin and hardener packaged in a single cartridge. When the barrier separating them is plunged, they begin to harden. Injected into a crack or cavity, it hardens within minutes or longer depending on temperature. The hardened system is dimensionally stable and virtually shrink-free.
Abojet 8610-1 meets ASTM C881 Type III, Grade 1, Class B, C.
Abojet 8610-3 meets ASTM C881 Types I and II, Grade 1, Class B, C.
Abojet 8702-3 meets ASTM C881 Type II, Grade 2, Class B, C.
Each 10 fluid ounce cartridge fills 18 cubic inches; nozzles included. Cartridges and nozzles sold separately for quart and gallon volume packaging.
|8610-3||< .5 in (1 cm)|
|8702-3||> .5 in (1 cm)|
Customer Questions & Answers
Q Recently, a corner in our basement began to leak when it rains. We now notice long cracks in the corner. Not clear yet from where the water is coming. If applied during a dry spell, will Abojet seal the leak, permanently? The basement is poured concrete, not blocks. ThanksAnswered by the admin
You can use Abojet on the structural wall cracks for seal the leaks. You'll have to dam up the cracks with Aboweld 55-1 while installing injection ports every 8-10 inches. The Abojet is applied through the ports.
Q I have an older masonry/brick chimney with some serious cracks. Would Abojet be the product to seal and repair these cracks?Answered by the admin No. Please call our technical department at 800-445-1754 to discuss.
Q I have a basement wall, standard "cinder block". Hairline cracks in the mortar due to settling. Is Abojet a good alternative to tuck pointing?Answered by the admin
No. Abojet is structural wall crack injection product.
Q Could this product be used on a large monument, i.e. grave monument? It is made up of several levels. The base is of cast concrete, where areas are crumbling away allowing the entry of moisture. It is from the 1880's.Answered by the admin
The Abojet is a structrual crack injection product. The Aboweld 55-1 may be a better product for your project.
Q Is a special "gun" needed to push the material out?Answered by the admin
You can use a standard caulking gun.