Multi-Glaze Type M Glazing Compound

Sarco Multi-Glaze Type M Glazing Compound. 

Quickest surface skinning product for inside shop use only. 

Sarco Multi-Glaze Type M is the best traditional knife grade linseed oil glazing compound available for glazing and bedding glass in wood sash and doors. Type M is the quickest surface skinning product and forms a strong surface skin in one week depending on temperatures. It remains elastic and flexible throughout its lifetime. Type M is for inside shop glazing only. Give Type M at least 14 days to cure before painting with oil or latex paint.

 

(2 customer reviews)
DescriptionUnitQtyPrice
1 Gallon
$53.50

Customer Questions & Answers

  1. Q What is the VOC content in g/L of this product? Is it LEED compliant?
    Answered by the admin VOC are less than 0.01%. It has not been tested to LEED compliance.
  2. Q What kind of pain should I use to paint over the glaze?
    Answered by the admin

    Any good, quality paint will be fine.

  3. Q Will the product adhere and cure where epoxy repairs are done on the glazing rabbet?
    Answered by the admin

    Yes

  4. Q I have have a new storm window that used type m on, now it has been 3 weeks and I have a few spots where the glazing is still soft and bubbly. I did not prime the window rabbit, I did apply BLO and mineral spirits 50/50 mix. all other window are good.
    Answered by the admin You should always prime prior to using the glazing compound.
  5. Q Storage of my container of Type M has failed. When new it started as extremely sticky and was almost impossible to spread; it stuck to my hands and tools like it was thick paint. I had to wait for a week or two before trying again and things went much better. I finished four windows and set aside the pail after putting a sheet of Sarah wrap on the putty before closing the lid. Three months later I needed to glaze another window but the putty was very dry and not usable. I had to throw away the top couple of inches in the pail and dig out some softer putty at the bottom to finish the job. What caused the drying?
    Answered by the admin

    The oil sinks to the bottom during long periods of storage. To prevent those types of issues you could store the tubs upside down, which would keep the oil at the top in between uses.

Send me a notification for each new answer.

Customer Reviews

  1. Mark N

    We restore historic wooden windows – This is our favorite

  2. Mike

    So far, this stuff is horrible. It’s extremely sticky and nearly to impossible to use. Cleanup of tools and my hands was very difficult. I would accept the stickiness if the instructions mentioned this possibility and what to do about it. The problem is there are no instructions. The side of the tub has only one sentence about allowing it to skim over before painting and that’s it. It’s possible that detailed instructions that cover common problems are available somewhere but, after searching the internet, I haven’t found it. I have found conflicting advice, however. This product should at least come with much more detailed instructions, rather than appearing to cater only to those who have been glazing windows for 30 years. I bought it because the DAP glazing compound is so maligned on the internet. I can’t imagine anything being worse than the Sarco putty.

    • ABATRON

      Please call our technical department at 800-445-1754 for assistance.

Add a review

Your email address will not be published. Required fields are marked *